Recycling Of Electronic Waste In The UK Environmental Sciences Essay

Published: 2021-09-29 13:00:04
essay essay

Category: Pollution, Manufacturing, Recycling, Electronic Waste

Type of paper: Essay

This essay has been submitted by a student. This is not an example of the work written by our professional essay writers.

Hey! We can write a custom essay for you.

All possible types of assignments. Written by academics

This chapter represents the decision and recommendations of this thesis related to E-waste direction in UK. First a sum-up of the E-waste direction in UK is discussed and further it is followed by recommendations in footings of betterment in the present patterns and techniques which are followed / used by the EEE makers, WEEE aggregation and recycling Centres etc in the UK and Europe, every bit good as for the farther research that could be done into this country of survey and these suggestions are intended to develop a comprehensive recycling system across the UK and Europe for optimum use of resources on the one manus and minimum pollution on the other.
5.1 Summary of the E-waste Management in UK:
The E-waste direction theoretical account involved assorted sub-models like proper aggregation, efficient processing and effectual system direction which can be used in the appraisal of costs and its environmental impacts within a specific geo-economic and political context.

The proper E-waste direction is capable of executing the implicit in three facets which are as follows:
The most economically efficient figure of aggregation sites and their locations based on a given population distribution
The most economically efficient figure of recycling sites and their locations based on modelled aggregation informations, and
The environmental impact associated with E-waste transit from an energy ingestion stand point
It is clear from the above treatment in chapter-4 that recycling of E-waste is a really critical capable affair from the point of waste intervention every bit good as from the recovery of valuable metals. It has besides been discussed that the economic ground is the most of import cause for recycling after environmental issue. Traditional method of E-waste disposal was related to set down filling and incineration. Incineration resulted into heavy emanation of green house and other toxic gases and landfill resulted into the loss of birthrate of agricultural land ( dirty pollution ) , H2O pollution etc. The other facet of this traditional method of waste disposal is that it has put heavy force per unit area on excavation of cherished metals as these cherished metals are needed for fabrication of new EEEs including Personal computers and laptops. So accordingly recycling is the best method for get bying up with the above jobs. It has besides been supported for the sale of economic benefits it is holding in footings of acquiring cherished metals after recycling for the farther usage in the fabrication of new Personal computers, laptops and other EEEs.
Our society is turning continuously and devouring more and more Personal computers and laptops. In UK, there is about every personal is holding one Personal computer and the replacing rate is high. So the unnatural addition in the E-waste is normal in these fortunes. But at the same clip authorities and the companies are really much concerned with the ill-impacts associated with the traditional methods of waste disposal. Traditional method of E-waste disposal is really risky for the environment and for the human wellness every bit good. So the complete prohibition on land filling and incineration is the obvious pick of the authorities of UK.
The authorities of UK has proposed and enacted the statute law for landfill prohibitions, EPR and ARF. ARF has been collected from the concluding consumers for funding the Personal computers and laptops ( although it besides charged on other EEEs ) . Therefore this thesis tries to try the inquiry that how the proper aggregation, disposal and recycling of E-waste can profit the environment and economic system of UK and how it can be improved.
Earlier, firing / incineration methods ( e.g. method utilizing IsaSmelt furnace ) had been used as a recycling procedure for retrieving cherished metals from E-waste but due to its restrictions there was a paradigm displacement in the recycling methods. Recently attendings have been moved to another method of recycling i.e. making a twister ( whirl ) and oppressing the E-waste for material recovery ( e.g. MeWa QZ 2000 Recycling Plant used by SWEEEP ) . Similarly there occurs a paradigm displacement in the recycling methods of batteries besides, i.e. from Hydrometallurgy to Robust Pyroprocess ( e.g. method used by Umicore Recycling Plant in Belgium ) .
The effectivity of these recycling procedures must be analysed in the visible radiation of benefits ( economically and environmentally ) derived from these procedures. These recycling methods offer a big measure of cherished metal recovery and separation of risky constituents ( table-16 & amp ; table-18 ) . The state of affairs would hold been black if this much measure of risky constituents incorporating E-waste was land filled or incinerated.
But on the other manus the major concerns for these recycling methods are the high power / energy demands and the high emanation of green house gases. In the twelvemonth 2009, the entire costs of electricity consumed by the SWEEEP 's MeWa Plant were ?55,527.88 ( both twenty-four hours and dark operations ) and the entire units of electricity consumed were 880,134 KWh ( table-13 ) . Similarly the energy demand for the Robust Pyroprocess is besides high, i.e. a‰? 1000 grade centigrade ( table-17 ) .
The bing E-wastes recycling systems diverge expressively non merely system architecture, but in their operating context. The population denseness and distributions, measures of E-waste generated, attitudes towards recycling, local labor costs and energy costs, are all features of contextual factors which influence the public presentation of E-waste recycling systems. Normally, the addition in the aggregation points of E-waste shows a relationship with the measures of E-waste collected and recycled. It is besides deserving adverting that it is the willingness of single to take part in E-waste recycling systems which have significantly bearings on the measure of E-waste collected.
5.2 Recommendations:
The recommendations have been drawn from the treatments in chapter-2, chapter-4 and from the above decisions of this thesis. These recommendations have been decently suggested for three different set of people as they have their ain specific function for the extenuation of environmental related ill-effect of the E-waste.
5.2.1 EEE Industries: Design & A ; Manufacture Products in an Eco-Friendly & A ; Trouble-free Manner:
The cost associated with processing E-waste are important to the overall E-waste system recycling costs. When merchandises are manufactured such that at EOL they can be easy dismantled, a greater per centum of stuff can be recovered, with less energy and at a lower cyberspace cost to the system. Therefore in order to help both environmental and economic ends of the E-waste system, makers should try to plan merchandises which can be easy disassembled. Many makers justly argue that such a design end is non ever achievable without extra costs to the fabrication house. For that makers should promote E-waste systems fiscal construction. Encourage E-waste Recycling Centres to Share Performance Data: `` Industry believes a national solution is required because conflicting province statute laws would take to uncertainnesss, inefficiencies and high conformity cost that will hinder their ability to be competitory and advanced. Industry is concentrating on attempts to make a national system that will accomplish the end of increasing recycling while non impeding interstate commercialism '' ( Wu, 2005 ) . The WEEE forum consists of many authoritiess and recycling Centres across the EU. These authoritiess and recycling Centres portion E-waste recycling systems and best patterns. But the paradox is that these establishment portions really limited informations i.e. many of the recycling Centres still non made their informations populace. So, these informations 's are non easy accessible by the general populace. It could be contributing for better E-waste direction. But once more it is the paradox that on the one manus the authorities is demoing its concerns for E-waste and jeopardies related to it and on the other manus making the monopoly over the methods used by its recycling Centres and attempts to maintain it secret every bit much as possible. The makers should promote the sharing of public presentation informations so that E-waste recycling system could be smooth.
5.2.2 E-waste Collection Centres & A ; Legislators ( Government ) :
The handiness of E-waste aggregation Centres is a really important feature of E-waste system architecture. So, it is really of import for the recycling Centres and authoritiess to find the figure of aggregation Centres and their handiness. They must believe over it that how far is the aggregation Centre from the residential country and how far an person is willing to go to lodge his / her E-waste. As we discussed earlier in chapter-4, in the instance of Cambridgeshire county council aggregation Centres, leting / doing some agreements for the disposal of E-waste from concerns and set uping some transit methods for the house to house aggregation of E-waste will promote and better the recycling and its efficiency.
It is an acceptable statement that consumer engagement is subjective and it is influenced by the distance to aggregation Centres and besides by other factors like age, instruction, income, peer force per unit area etc. Harmonizing to a study conducted by the Cambridgeshire county council aggregation Centre ( 2010 ) , it was estimated that 20 % of the people in UK still believe that they ca n't / it is non possible to recycle E-waste but the staying 80 % believes that by taking more attempt E-wastes can be recycled. So organising or making more public consciousness programme ( e.g. advertisement, originative attacks etc ) can do more people aware of the sick effects of E-waste and the advantages of it 's recycling. The engagement of the staying 20 % people in the E-waste recycling programme will decidedly lend to the protection of the environment and to the nest eggs in economic system in a great mode.
5.2.3 E-waste Recycling Centres:
Most of the recycling centres across UK and Europe are utilizing latest method for recycling WEEE and batteries. Even though these methods are effectual in recycling and retrieving big measures of cherished metals, it has got some disadvantages like high power / energy demand, big emanation of green house gases etc which requires heavy attending. SWEEEP Recycling Centre:
The power demand for the MeWa QZ 2000 recycling works is really high. This demand of high power can be reduced if the demand for an external heavy granulator ( for doing the size of the end product material uniform ) is avoided by including the map of the heavy granulator within the MeWa works itself or by developing some other maps related to it. The exposure of operators to the risky constituents ( manus picking booth ) for separation of non-uniform stuffs can besides be avoided to some extent as a consequence of such a development, since the unvarying size of the end product stuff avoids the demand of manual separation. Umicore Battery Recycling Centre:
The energy demand for Robust Pyroprocess method of recycling used by Umicore is high. Another disadvantage of this method is the emanation of green house gases to the environment. The installing of an off-gas emanation control system for retrieving and recycling these expelled gases will be a better solution for cut downing the energy demand and for forestalling the emanation of green house gases during this procedure. In short by salvaging and cut downing the sum of energy required for recycling, the emanation of green house gases can be minimised / stopped and therefore helps forestall planetary clime alteration.
5.3 Future Suggestions:
This thesis has specific frame work under which E-waste direction in UK has been considered. The points of particular accent were the recovery of cherished metals, advantages and disadvantages of the methods used for retrieving ( recycling ) these cherished metals which includes high power /energy demand, emanation of green house gases etc. Due to the limited handiness of informations and limited every bit good as restricted entree to the assorted E-waste recycling Centres, the observation and decision can said to be conclusive. Extra apprehension can be gained through utilizing more elaborate population distribution informations analysis with assorted theoretical accounts, and utilizing these theoretical accounts to excite extra combinations of system architecture and system context.
This thesis will move as a platform for farther research on the subject of recycling of E-waste with particular accent on the Personal computers and laptops. The farther research could be undertaken for the intent of obtaining comprehensive apprehension on the recovery of assorted cherished metals and the methods undertaken for the intent of recovery. The broader probe and analysis of informations including the entree of assorted recycling Centres would unwrap the ingestion of electricity in order to derive cognition about full process-based cost theoretical account. After this, one can state exactly about the cost benefit analysis of E-waste direction with particular mentions to Personal computers and laptops.

Warning! This essay is not original. Get 100% unique essay within 45 seconds!


We can write your paper just for 11.99$

i want to copy...

This essay has been submitted by a student and contain not unique content

People also read